| 國立成功大學 |
2020-11 |
Biodegradation ZK50 magnesium alloy compression screws: Mechanical properties, biodegradable characteristics and implant test
|
Chen;Yen-Ting;Hung;Fei-Yi;Lin;Yen-Ling;Lin;Chia-Yen |
| 國立成功大學 |
2020-07~2020-08 |
Improving the applicability of wear-resistant Al-10Si-0.5 Mg alloy obtained through selective laser melting with T6 treatment in high-temperature, and high-wear environments
|
Chen;Kuan-Jen;Hung;Fei-Yi;Lui;Truan-Sheng;Tsai;Chun-Lin |
| 國立成功大學 |
2020-06 |
Wedge bonding technologies: microstructure, mechanical properties and electrical properties of fine Al-Zn-Si alloy wire
|
Wu;Bo-Ding;Hung;Fei-Yi |
| 國立成功大學 |
2020-05~2020-06 |
Microstructure and tensile fracture behavior of three -stage heat treated inconel 718 alloy produced via laser powder bed fusion process
|
Zhao;Jun-Ren;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2020-03 |
Microstructure, optical, electrical, and magnetic properties of ZnO/CuO thin films prepared using two-stage magnetron sputtering and diffusion doping process
|
Liu;Tai-Hsiang;Hung;Fei-Yi;Chen;Cheng-Hung;Chen;Kuan-Jen |
| 國立成功大學 |
2020-03 |
A New Infrared Heat Treatment on Hot Forging 7075 Aluminum Alloy: Microstructure and Mechanical Properties
|
Chang;Yi-Ling;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2020-01 |
Opto-electromagnetic properties of carbon-doped zinc-oxide prepared using electrically induced crystallization and ion implantation process for gas sensor application
|
Liu;Tai-Hsiang;Hung;Fei-Yi;Chien;Tao;Chen;Kuan-Jen |
| 國立成功大學 |
2020-01 |
Erosion Resistance and Particle Erosion-Induced Tensile Embrittlement of 3D-Selective Laser Melting Inconel 718 Superalloy
|
Zhao;Jun-Ren;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2019-12 |
Study of electrical fatigue test in gold-coated siliver-4 wt.% palladium bonding wire
|
Ho;Chen-Chin;Chen;Kuan-Jen;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2019-08 |
Biodegradable Implantation Material: Mechanical Properties and Surface Corrosion Mechanism of Mg-1Ca-0.5Zr Alloy
|
Chen;Yen-Ting;Hung;Fei-Yi;Syu;Jie-Cheng |
| 國立成功大學 |
2019-08 |
Low Conductivity Decay of Sn-0.7Cu-0.2Zn Photovoltaic Ribbons for Solar Cell Application
|
Chen;Kuan-Jen;Hung;Fei-Yi;Lui;Truan-Sheng;Hsu;Lin |
| 國立成功大學 |
2019-07 |
A Study of the Sulfidation Behavior on Palladium-Coated Copper Wire with a Flash-Gold Layer (PCA) after Wire Bonding
|
Chen;Kuan-Jen;Hung;Fei-Yi;Chang;Chia-Yun |
| 國立成功大學 |
2019-07 |
Particle Erosion Induced Phase Transformation of Different Matrix Microstructures of Powder Bed Fusion Ti-6Al-4V Alloy Flakes
|
Zhao;Jun-Ren;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2019-05~2019-06 |
Impact of solid-solution treatment on microstructural characteristics and formability of rotary-swaged 2024 alloy tubes
|
Lin;Chia-Wei;Chen;Kuan-Jen;Hung;Fei-Yi;Lui;Truan-Sheng;Chen;Hsuan-Po |
| 國立成功大學 |
2019-05 |
The Relationship of Fracture Mechanism between High Temperature Tensile Mechanical Properties and Particle Erosion Resistance of Selective Laser Melting Ti-6Al-4V Alloy
|
Zhao;Jun-Ren;Hung;Fei-Yi;Lui;Truan-Sheng;Wu;Yu-Lin |
| 國立成功大學 |
2019-03-15 |
The effect of hyper-rotation on the Weibull distribution of tensile properties in a friction stirred AA7075 aluminum alloy
|
Ku;Ming-Hsiang;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2019-02 |
Examination of the High Tensile Ductility Improvement in an As-Solutionized AA7075 Alloy with the Aid of a Friction Stir Process
|
Ku;Ming-Hsiang;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2019-01~2019-03 |
Study of microstructure and tensile properties of infrared-heat-treated cast-forged 6082 aluminum alloy
|
Chang;Yi-Ling;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2019-01-2 |
Embrittlement Due to Excess Heat Input into Friction Stir Processed 7075 Alloy
|
Ku;Ming-Hsiang;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2019 |
Wear Inducing Phase Transformation of Plasma Transfer Arc Coated Tools during Friction Stir Welding with Al Alloy
|
Chen;Kuan-Jen;Hung;Fei-Yi;Lui;Truan-Sheng;Shih;Yong-Ren |
| 國立成功大學 |
2018-10 |
Studies of Interfacial Microstructures and Series Resistance on Electroplated and Hot-Dipped Sn-xCu Photovoltaic Modules
|
Chen;Kuan-Jen;Hung;Fei-Yi;Lui;Truan-Sheng;Hsu;Lin |
| 國立成功大學 |
2018-09 |
Effects of Static Heat and Dynamic Current on Al/Zn center dot Cu/Sn Solder/Ag Interfaces of Sn Photovoltaic Al-Ribbon Modules
|
Chen;Kuan-Jen;Hung;Fei-Yi;Lui;Truan-Sheng;Lin;Wen-Yu |
| 國立成功大學 |
2018-08 |
Enhanced Formability and Accelerated Precipitation Behavior of 7075 Al Alloy Extruded Rod by High Temperature Aging
|
Ku;Ming-Hsiang;Hung;Fei-Yi;Lui;Truan-Sheng;Lai;Jyun-Jhih |
| 國立成功大學 |
2018-08 |
Study on characteristics of interfacial microstructure and electrical current mechanism in Sn-xZn/Al photovoltaic modules
|
Lin;Chia-Wei;Hung;Fei-Yi;Lui;Truan-Sheng;Huang;Di-Jung |
| 國立成功大學 |
2018-07 |
Enhancement of Mechanical Properties of Hot-Forged 6082 Suspension Parts via Rapid IR Heat Treatment
|
Chang;Yi-Ling;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2018-04-14 |
The charge-discharge characteristics and diffusion mechanism of Ti-Si-Al thin film anode using an electrically induced crystallization process
|
Chen;Yen-Ting;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2018-04 |
Enhancement of the Young's Modulus through Infrared Heat Treatment: A Study of the Microstructure and the Mass Effect of Real Body 6082 Aluminum Forgings
|
Chang;Yi-Ling;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2018-01 |
Microstructure Evolution and Microstructural Characteristics of Al-Mg-Si Aluminum Alloys Fabricated by a Modified Strain-Induced Melting Activation Process
|
Lin;Chia-Wei;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2018 |
Effects of Tempered Microstructure and Hydrogen Concentration on Hydrogen-Induced Embrittlement Susceptibility of 10B21 Screws at Low Temperature
|
Chen;Kuan-Jen;Hung;Fei-Yi;Lui;Truan-Sheng;Tseng;Chien-Hao |
| 國立成功大學 |
2018 |
Microstructure and High Temperature Charge-Discharge Characteristics of 3D Additive Manufacturing Produced Mg-Ni Anode
|
Chen;Yen-Ting;Hung;Fei-Yi;Lui;Truan-Sheng;Tan;Huey-Pyng |
| 國立成功大學 |
2017-11-1 |
Development of a novel micro-textured surface using duplex surface modification for biomedical Mg alloy applications
|
Lin;Da-Jun;Hung;Fei-Yi;Yeh;Ming-Long;Lee;Hung-Pang;Lui;Truan-Sheng |
| 國立成功大學 |
2017-11 |
Dynamic Corrosion and Material Characteristics of Mg-Zn-Zr Mini-Tubes: The Influence of Microstructures and Extrusion Parameters
|
Lin;Da-Jun;Hung;Fei-Yi;Liu;Heng-Jui;Yeh;Ming-Long |
| 國立成功大學 |
2017-11 |
Development of a Novel Degradation-Controlled Magnesium-Based Regeneration Membrane for Future Guided Bone Regeneration (GBR) Therapy
|
Lin;Da-Jun;Hung;Fei-Yi;Lee;Hung-Pang;Yeh;Ming-Long |
| 國立成功大學 |
2017-08-15 |
Enhancing the tensile yield strength of A6082 aluminum alloy with rapid heat solutionizing
|
Chang;Yi-Ling;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2017-07 |
Mechanical and Electrical Properties of Palladium-Coated Copper Wires with Flash Gold
|
Chang;Chia-Yun;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2017-05 |
Correlation between Anti-Corrosion Performance and Optical Reflectance of Nano Fluoride Film on Biodegradable Mg-Zn-Zr Alloy: a Non-Destructive Evaluation Approach
|
Lin;Da-Jun;Hung;Fei-Yi;Yeh;Ming-Long;Lee;Hung-Pang;Lui;Truan-Sheng |
| 國立成功大學 |
2017-05 |
Aluminium Wires Have the Free Air Balls (FABs): Electronic Flame-Off, Fracture Strength, Electrical Properties, and Bonding Characteristics of Nano Zn Film Al-Si Bonding Wires
|
Hung;Fei-Yi;Lui;Truan-Sheng;Chu;Kuan-Ming;Tseng;Yi-Wei |
| 國立成功大學 |
2017-01-16 |
A study on electromigration-inducing intergranular fracture of fine silver alloy wires
|
Hsueh;Hao-Wen;Hung;Fei-Yi;Lui;Truan-Sheng |
| 國立成功大學 |
2017 |
Effects of Friction Stir Process and Stabilization Heat Treatment on Tensile Characteristics and Punch-Shear Properties of AZ61 Alloy
|
Chen;Hsiang-Ching;Hung;Fei-Yi;Lui;Truan-Sheng;Chen;Li-Hui |
| 國立成功大學 |
2017 |
Microstructures and Charge-Discharging Properties of Selective Laser Sintering Applied to the Anode of Magnesium Matrix
|
Chen;Yen-Ting;Hung;Fei-Yi;Lui;Truan-Sheng;Hong;Jia-Zheng |
| 東海大學 |
1992 |
古吳墨浪子《西湖佳話》研究
|
費懿; Fei, Yi |
